The MachineWise Pilot Programme

Two machines. Thirty days. Zero cost to start.

Q: Is the MachineWise pilot really free?

Yes. There is nothing to pay to start and no obligation afterwards. We run pilots because measured numbers on your own machines make the case better than any presentation.

Q: Which machines can be in the pilot?

Any two: CNC machines, VMCs and lathes, presses, injection moulding machines, furnaces or conventional machines with no controller. Pick the two that frustrate you most.

Q: Will the pilot stop production?

No. Software-first setup takes under an hour per machine with no stoppage, and machines keep running normally throughout.

Q: Where is the pilot data stored?

On-premises, inside your plant. Your data never leaves your network.

Q: What do we get at the end?

A measured 30-day downtime and OEE report for the two machines and a plant-wide ROI model at your machine rates. You keep both whatever you decide.

Q: What happens after the pilot?

Most plants extend MachineWise to the rest of the floor; roughly 8 in 10 pilots convert. If you do not, you keep the report and nothing else happens.

Stop evaluating slideware. We put live OEE on two of your machines this week and let the numbers make the case. Your data stays on-premises the whole time.

WhatsApp us instead How the pilot works

₹0 to startNo stoppageUnder an hour per machineReport + ROI model at day 30

<1 hrSetup per machine, zero stoppage

₹0To start, and no obligation after

30 daysOf measured, second-by-second data

~8 in 10Pilots that extend to the full floor

How it works

From a phone call to a measured answer.

Day 0

A 20-minute call

We pick the two machines with you. Usually the two most frustrating ones: they make the best case.

Week 1

Two machines live

Software-first setup in under an hour each, with no stoppage. Legacy machine? A MachineWise gateway covers it.

Weeks 1–4

Every second recorded

Machine states, stops with reasons, part counts and OEE, plus WhatsApp shift summaries.

Day 30

Report and ROI model

A measured downtime and OEE report for your two machines and a plant-wide ROI model at your rates.

Then

You decide

Extend to the floor, or keep the report with our compliments. No lock-in, no pressure.

What you get

A measured answer, not a promise.

Live

Your two machines on a dashboard

Machine states, stops and reasons, part counts and OEE, live from the first week, on your LAN.

Daily

WhatsApp shift summaries

You feel the difference every day, not at month-end: OEE, top loss and parts per shift.

Day 30

The report and the ROI model

A measured downtime and OEE report, and a plant-wide ROI model at your own machine hour rates.

Who it is for

Any plant that runs machines.

Fit

5 machines or 500

CNC shops, moulders, forges, furnaces, presses, assembly lines. If it runs machines, the pilot works.

Machines

New CNCs to 1985 presses

Controllers are connected read-only; machines with nothing to read get a MachineWise gateway.

The catch

There isn't one

We run free pilots because measured numbers close better than salespeople. Roughly 8 in 10 pilots convert; the rest keep the report.

Before you book

Useful before the first call.

Questions

Pilot questions, answered.

Is the MachineWise pilot really free?